Table of Contents
Advertisement
Installing
Place the stove on a noncombustible floor protector
that extends 6 inches to the front, 6 inches to the sides
and 1 inch to the rear of the stove. The minimum floor
protector material is 24 gauge sheet metal.
Place the stove away from combustible walls at least
as far as shown in figures 3,4 and 5. Please note the
difference in side wall clearance with and without side
shields.
Note that the clearances shown are minimum for
safety but do not leave much room for access when clean-
ing or servicing. Please take this into account when plac-
'ing the stove.
Connect the power cord to a 120 V.A.C. 60Hz
grounded receptacle. (A surge protector is recommened
to protect the circuit board).
Prior to installing the flue pipe, connect a draft meter
to the stove as shown in fig. 6. (The draft meter must
have a minimum range of 0-.5). However, prior to taking
the draft reading be sure all doors and windows in the
home are closed. Record the draft reading
.
If
this reading is more than .05" lower than the unconnected
reading, check for possible restrictions or the need for
outside air (see page 8).
Mobile Home Installation
When insblling this unit in a mobile home several re-
quirements must be followed:
1. The unit mu& be bolted to the floor. This can be
2
done with 114" lag screws through the 2 holes in the base
plate.
2. The unit must also be connected for the outside air.
See page 8.
3. Floor protection and clearances must be followed
as shown.
4. Unit must be grounded to the metal frame of the
mobile home.
CAUTION: This appliance must be vented to the out-
side.
Due to high temperatures, the stove should be placed
out of - c
and away from
furniture
and draperies.
Children and adults should be alerted to the hazards of
high surface temperatures and should stay away to avoid
burn to skin andlor clothing.
Young children should be carefully supervised when
they are in the same room as the stove.
Clothing and other flammable materials should not be
placed on or near this unit.
Installation and repair of this Harman Stove should be
done by a qualified service person. The appliance should be
inspected before use and at least annually by a qualified
service person. More frequent cleaning will be required. It
is imperative that control compartments, burners, and circu-
lating air passageways of the stove be kept clean.
9 "
With Side Shields
13" Without Side Shields
\/
Fig. 3
-
Fig.
4
u
FLOOR PROTECTOR
1
Fig. 5
I
d
Advertisement
Table of Contents
