Assembly - Harman Stove Company Clarity 929bv Installation & Operating Manual

asseMblY

The.Clarity.is.shipped.from.the.factory.with.the.log.set.
packed inside the firebox. To prepare the stove for installa-
tion,.the.log.set.must.be.unpacked,.the.appropriate.burner.
system.module.for.either.natural.gas.or.propane.installed,.
and.the.logs.installed.
Removing the Glass Front
NOTE:. The. glass. front. is. heavy.. Be. prepared. for. its.
weight.when.lifting.it.to.avoid.damage.during.removal.
The.wing.doors.on.each.side.are.held.closed.by.magnets..
Push.on.each.door.to.open.it..Loosen.the.wing.nut.on.each.
of.the.two.levers..Grasp.each.lever.and.push.to.the.rear.to.
disengage.the.front..To.keep.the.levers.in.the.disengaged.
position,.tighten.the.wing.nuts..Lift.the.glass.front.slightly.
and.remove.it.from.the.stove..Set.the.glass.aside.in.a.safe.
place.where.it.will.not.be.damaged.
WaRnInG: Do not abuse the Clarity's glass by
striking, slamming, or similar trauma. Do not oper-
ate the Clarity Vented Gas Heater with the glass panel
removed,
cracked or broken. Use only glass supplied by Harman
and approved for use with this heater. Do not use substi-
tute materials. Replacement of the panel should be done
by a licensed or qualified service person.
Remove and Unwrap the Log Set
As.shown.in.the.photo.above.right,.the.log.set.consists.
of.a.back.log.(1),.a.center.log.that.has.a.pilot-viewing.port.
in.the.left.end.(2),.ember.strip.(3),.and.a.branch.that.rests.on.
top.(4)..
In.addition,.there.are.two.side.brick.panels.and.a.back.
brick.panel.
The.front.is.released.when.
levers.on.the.left.and.
right.sides.are.pushed.to.
the.rear

1
3
The. log. set. components. are. shipped. from. the. factory. .
individually.wrapped.and.packed.inside.the.stove..Take.them.
out.of.the.stove,.then.carefully.remove.the.wrapping..Handle.
the.logs.gently.as.they.may.be.damaged.easily.
2
4