Nexcom Peak 550 User Manual page 38

Peak 550 User's Guide
Boot Up NumLock Status
The default value is On.
On
Off
Boot Up System Speed
It selects the default system speed - the speed that the system will run at
immediately after power up.
High
Low
Gate A20 Option
Normal The A20 signal is controlled by keyboard controller
or chipset hardware.
Fast Default : Fast. The A20 signal is controlled by Port
92 or chipset specific method.
Typematic Rate Setting
This determines the typematic rate.
Enabled Enable typematic rate and typematic delay
programming
Disabled Disable typematic rate and typematic delay
programming. The system BIOS will use default
value of this 2 items and the default is controlled by
keyboard.
Typematic Rate (Chars/Sec)
6
8
10
12
15
20
24
BIOS Setup
Keypad is number keys
Keypad is arrow keys
Set the speed to high
Set the speed to low
6 characters per second
8 characters per second
10 characters per second
12 characters per second
15 characters per second
20 characters per second
24 characters per second
4- 16