Nexcom Peak 550 User Manual page 33

Peak 550 User's Guide
Error halt
The category determines whether the computer will stop if an error is detected
during power up.
No errors
All errors
All,But Keyboard
All, But Diskette
All, But Disk/Key
Memory
The category is display-only which is determined by POST (Power On Self Test) of the
BIOS.
Base Memory
The POST of the BIOS will determine the amount of base (or conventional)
memory installed in the system. The value of the base memory is typically
512K for systems with 512K memory installed on the motherboard, or 640K for
systems with 640K or more memory installed on the motherboard.
Extended Memory
The BIOS determines how much extended memory is present during the
POST. This is the amount of memory located above 1MB in the CPU's memory
address map.
Other Memory
This refers to the memory located in the 640K to 1024K address space. This is
memory that can be used for different applications. DOS uses this area to load
device drivers to keep as much base memory free for application programs.
Most use for this area is Shadow RAM.
Total Memory
BIOS Setup
Whenever the BIOS detects a non-fatal error the system will be
stopped and you will be prompted.
The system boot will not be stopped for any error that may be
detected.
The system boot will not stop for a keyboard error; it will stop for all
other errors.
The system boot will not stop for a disk error; it will stop for all other
errors.
The system boot will not stop for a keyboard or disk error; it will stop
for all other errors.
4- 11