Removing the Mirrors
Step 1
Remove the mirror glass from the housing.
Start with the bottom smaller mirror.
Tilt the top of the mirror inward. Place
fingers underneath. Pull straight forward
to release. The mirror is held in place with
small snap clips around the center mount.
Repeat the same steps with the larger
upper mirror.
CAUTION
Use even pressure to remove the mirror
glass. The glass can shatter if not removed
correctly.
Step 2
There are 6 preasure snaps and 2 x T10
torx screws holding the mirror cap in place.
Remove the 2 x T10 torx screws holding
the turn signal or the blank in place.
Use needle nose pliers to gently squeeze
the tabs to release the mirror cap.
Illustrations are typical and may not match exact vehicle details
email - support@aampglobal.com (US)
12
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - technical.eu@aampglobal.com (Europe)
IIntegrated Safety System
Ford Transit - Non-Tow Mirrors
FCTP-FT1602