Ferro GPA II Installation And Operation Manual page 53

4. INSTALLATION OF GPA II SERIES PUMP
4.1. Installation
• Install GPA-II series motor pump, with arrows indicating the direction of medi-
um flow.
• Install two gaskets must be set at the inlet and the outlet before installing the
pump in the pipeline.
• Pump shaft must be positioned horizontally.
1
1
4.2. Position of Junction Box
1
4.3. Changing the position of Junction Box
The junction box can be rotated in intervals 90°
To change the position of the junction box:
1. Close the inlet and outlet valve, depressurize the equipment
2. Loosen and remove four hex screws fixed the motor.
3. Rotate the motor to the desired position and match the openings.
4. Put the four hex screws into the openings and turn clockwise.
5. Open the inlet and outlet valve.
2
2 3
2
3
4 5
3
EN
4
6
4