Table of Contents
Advertisement
11.5
Visualization
When the communication with the computer port is established (see section 11.2), the tab
"Visualization" opens. This tab lets you view real-time flow rate, totalizer and velocity values, as
well as the current value of the analog output and the state of the relay outputs.
It is an intuitive tool to verify that the instrument has been installed and programmed correctly.
11.6
Simulation
If the converter CU100 is not available, the software can be used in simulation mode.
To do this, press the button "Enter" in the simulation section on the initial screen (see figure on
page 38).
Tabs "Installation" and "Programming" will open.
You will be able to calculate the distance between the transducers and change the data,
although they may not be sent to the converter.
43
Advertisement
Table of Contents
