Heating Of The Sauna; Erhitzen Der Saunakabine - Harvia D23XE Instructions For Installation And Use Manual

Electric sauna heater
Table of Contents

Advertisement

EN

1.2. Heating of the Sauna

When the heater is switched on for the first time,
both the heater and the stones emit smell. To remove
the smell, the sauna room needs to be efficiently
ventilated.
The purpose of the heater is to raise the
temperature of the sauna room and the sauna
stones to the required bathing temperature. If the
heater output is suitable for the sauna room, it will
take about an hour for a properly insulated sauna to
reach that temperature. See item 2.1., "Insulation
an Wall Materials of the Sauna Room". A suitable
temperature for the sauna room is about + 65 °C
– +80 °C.
The sauna stones normally reach the required
bathing temperature at the same time as the sauna
room. If the heater capacity is too big, the air
in the sauna will heat very quickly, whereas the
temperature of the stones may remain insufficient;
consequently, the water thrown on the stones
will run through. On the other hand, if the heater
capacity is too low for the sauna room, the room will
heat slowly and, by throwing water on the stones,
the bather may try to raise the temperature of the
sauna. However, the water will only cool down the
stones quickly, and after a while the sauna will not
be warm enough and the heater will not be able to
provide enough heat.
In order to make bathing enjoyable, the heater
capacity should be carefully chosen to suit the
size of the sauna room. See item 2.3. "Heater
Output".
Figure 1. Piling of the sauna stones
Abbildung 1. Aufschichtung der Saunaofensteine
DE
In der Steinkammer oder in der Nähe des Sau-
naofens dürfen sich keine Gegenstände oder Gerä-
te befinden, die die Menge oder die Richtung des
durch den Saunaofen führenden Luftstroms ändern,
und somit eine Überhitzung der Widerstände sowie
Brandgefahr der Wandflächen verursachen!

1.2. Erhitzen der Saunakabine

Beim ersten Erwärmen sondern sich von Saunaofen
und Steinen Gerüche ab. Um diese zu entfernen,
muß die Saunakabine gründlich gelüftet werden.
Die Funktion des Saunaofens ist es, die Saunakabine
und die Ofensteine auf die Aufgußtemperatur zu brin-
gen. Wenn die Leistung des Saunaofens an die Größe
der Saunakabine angepaßt ist, erwärmt sich eine gut
wärmeisolierte Sauna auf Aufgußtemperatur in etwa
einer Stunde. Siehe Kapitel 2.1. "Isolation der Sau-
nakabine und Wandmaterialien". Die passende Tem-
peratur in der Saunakabine beträgt etwa +65 °C bis
+80 °C.
Die Saunaofensteine erwärmen sich auf Aufguß-
temperatur gewöhnlicht in derselben Zeit wie die
Saunakabine. Ein zu leistungsstarker Saunaofen
erwärmt die Saunaluft schnell, aber die Steine blei-
ben untererhitzt und lassen so das Aufgußwasser
durchfließen. Wenn andererseits die Saunaofenlei-
stung in Bezug auf die Größe der Saunakabine ge-
ring ist, erwärmt sich die Saunakabine langsam und
der Saunabader wird versuchen, die Saunatempera-
tur durch einen Aufguß (durch Gießen von Wasser
auf den Saunaofen) zu erhöhen. Das Aufgußwasser
kühlt aber nur die Saunaofensteine schnell ab und
nach einer Weile reicht die Temperatur in der Sauna
nicht mehr für einen Aufguß aus.
Damit Sie beim Saunen die Aufgüsse genießen
können, sollten Sie die Leistung des Saunaofens in
Bezug auf die Saunakabine anhand der Broschüren-
informationen sorgfältig auswählen. Siehe Kapitel
2.3. "Leistung des Saunaofens".
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

D29xeD36xe

Table of Contents