Mercedes-Benz GLS Owner's Manual page 125

122 Seats and stowing
Setting automatic seat adjustment
& WARNING Risk of becoming trapped
during adjustment of the driver's seat
after calling up a driver profile
Selecting a user profile may trigger an
adjustment of the driver's seat to the posi‐
tion saved under the user profile. You or
other vehicle occupants could be injured in
the process.
Make sure that when the position of
#
driver's seat is being adjusted using the
multimedia system, no people or body
parts are in the seat's range of move‐
ment.
If there is a risk of someone becoming trap‐
ped, stop the adjustment process immedi‐
ately:
a) Tap the warning message on the
#
media display.
or
b) Press a memory position button or a
#
seat adjustment switch on the driver's
door.
The adjustment process will be stop‐
ped.
Requirements:
Adapting the driver's seat and steering wheel
R
position to body size: automatic seat adjust‐
ment has been switched on.
Multimedia system:
© Settings Vehicle
4 5 5
Automatic seat adjustment
5
Switching automatic seat adjustment on/off
When the active user profile is changed while
the vehicle is stationary, the driver's seat, steer‐
ing wheel, outside mirrors and seat contour will
automatically be adapted to the driver.
Select On or Off.
#
% This setting is available only for individual
user profiles. For the guest profile, auto‐
matic seat adjustment cannot be switched
on or off. Further information about user
profiles .
Adjusting driver's seat and steering wheel
position to body size
The vehicle calculates a suitable driver's seat
and steering wheel position on the basis of the
driver's body size and sets this directly.
To set the unit of measurement: select
#
or ft/in.
Set the size using the scale.
#
Select Start positioning.
#
The driver's seat and steering wheel position
is adjusted to the body size that has been
set.
% If the driver's seat and steering wheel posi‐
tion calculated by the vehicle is not practical
or comfortable, it can be manually changed
at any time via the buttons.
The exterior mirrors are not set via this func‐
tion. Instead, they have to be set manually
via the switches.
cm