Chaining Off And Test Sewing; Information - Bernette b48 FUNLOCK Instruction Manual

1
1
1
1
40
CHAINING OFF AND TEST
SEWING
–
–
–
–
–
–
–
–

Information

A mark
on the presser foot fitted on this machine. Use this
mark as a guide when sewing.
1
1
1
1
PLEASE NOTE:
The following instructions do not apply to cover-
stitch. For instructions on coverstitch, see
page 51 "How to Sew a Coverstitch."
When the machine is completely threaded,
bring all of the threads across the stitch plate
and slightly to the left under the presser foot.
Lower the presser foot to activate the thread
tensions.
Hold the threads and apply a slight tension.
Turn the handwheel toward you 2 or 3 complete
turns to start the thread chain.
Continue holding the chain and press on the
foot controller until the chain is 5–7.5 cm (2–3
inches) in length.
Place fabric under the front of the presser foot
and sew a test sample.
PLEASE NOTE:
Do not pull on the fabric while sewing as this
may deflect the needle, causing it to break.
At the end of the sample, continue to run the
machine with the presser foot down until the
chain reaches 15–20 cm (6–8 inches) in length.
PLEASE NOTE:
In case it is difficult to chain off and pull the fab-
ric lightly backward.
Cut thread.
PLEASE NOTE:
Anytime you have rethreaded the machine
always chain off and sew a text sample to test
tensions and make adjustments as necessary.
(1)
to indicate the needle location is provided