Bernette b48 FUNLOCK Instruction Manual page 35

3 2
3
3
6
7
6
7
8
9
10
6
7
8
9
10
8
9
10
34
2
3
3
3
4
5
4
5
4
5
10
10
10
– Thread the pre-tension guide by pulling the
thread towards the left until it slips under guide
(2)
. Then pull thread along the right side of pre-
tension as illustrated.
– While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
(3)
the tension discs
– Continue to thread points
PLEASE NOTE:
Slip thread into the front slot on the thread guide
(5)
and lower slot of take-up lever cover
Then slip thread into the left slot on the thread
(7)
guide , and into the left slot on the thread
(8)
guide .
Before threading eye of needle, slip thread behind
(9)
thread guide located on the bottom of the needle
holder for Coverstitch.
– Thread the eye of the left needle
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.
– The position of the thread must be behind the
thread guide.
– Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
.
(4) 10).
–(
(6)
.
(10)
.