Bernette b48 FUNLOCK Instruction Manual page 32

10
10
10
9
10
9
9
10
10
– Continue to thread points
PLEASE NOTE:
Slip thread into the rear slot on the thread guide
(5)
Then slip thread into the right slot on the thread
guide
guide
Before threading the eye of the needle, make sure
thread is in front of thread guide located on the bottom
of the needle holder
– Thread the eye of the right needle
PLEASE NOTE:
10
Use of tweezers in the looper cover will make
needle eye threading easy.
– The position of the thread must be behind the
thread guide.
10 – Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
10
– Place the thread to the back, under the presser
foot.
• Center Coverstitch/Chainstitch Needle
(Green)
(D On Needle Clamp)
Be sure to turn off power switch.
– Raise the presser foot to open the tension
discs.
– Thread the center coverstitch/chainstitch
needle as indicated
(4)
and bottom slot of take-up lever cover
(7)
, and into the right slot on the thread
(8)
.
(9)
.
CAUTION:
(10)
(1)–
10).
–(
(6)
.
(10)
.
.
31