Bernette b48 FUNLOCK Instruction Manual page 30

2
3
3
6
7
8
9
6
10
7
8
9
6
10
7
8
9
10
3
2
3
3
4
5
4
5
4
5
9
10
9
10
9
10
– Thread the pre-tension guide by pulling the
thread towards the right until it slips under guide
(2)
. Then pull thread along the right side of pre-
tension as illustrated.
– While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
(3)
the tension discs
– Continue to thread points
PLEASE NOTE:
Slip the thread into the middle slot on the thread
(5)
guide and into the slot on the take-up lever
(6)
cover .
Then slip the thread into the middle slot
on the thread guides
Before threading eye of needle, slip thread behind
(9)
thread guide located on the bottom of the needle
holder.
– Thread the eye of the left needle
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.
– The position of the thread must be behind the
thread guide.
– Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
.
(4) 10)
–( .
(7) (8)
and .
(10)
.
29