System Ready For Use - Environmental Water Systems EWS-SPECTRUM Product And Installation Manual

open outlet for service and go through a checklist to avoid any issues
17. OPeN OUTLeT ON THe bYPASS
TO PUT THe SYSTeM IN FINAL SeRVICe POSITION
18. System is ready for use.
Turn on gas or electric supply to the water heater(s).
To ready home for filtered water, please flush all the water throughout the home.
open as many hot and cold faucets through out the home as possible,
remove the aerators or any restriction at the end of the faucets,
run tubs,
flush toilets,
dispose of any ice previously made
run water throughout home for 5 minutes.
19. Final Checklist
check all connections,
pressure not to exceed 75 psi,
make sure system was not installed backwards
using the proper flexible piping
make sure drain is correctly installed and drain water was running clear.
NoTe: Cloudy WATer
If water appears cloudy, allow to run for several more minutes until all air is expelled or until clear.
NoTe: Pre-exIsTING CoNdITIoNs, older HoMes, HeAvy sedIMeNT
If home is a year or more old, it is highly recommended that all water heaters or tankless on-demand
heaters be flushed and that all dishwashers, washers and any other water appliances be cleaned of
any existing resi due.
Please review Page 7 "Instructions Before Using" for existing plumbing and pre-existing conditions
that will effect the performance of this system.
WARNING:
Failure to follow these procedures can result in debris in the system, the system's valve, the home,
and/or filtration media being expelled. Expelled media will cause immediate short and long term
issues with the system's valve, and will enter pipes and the fixtures or appliances within the home.
open inlet & outlet
system is in service position
16
outlet
inlet