Quectel EM05-G Hardware Design page 11

And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna
installation and operating configurations of this transmitter, including any applicable source-based
timeaveraging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion
Requirements of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user's
body and must not transmit simultaneously with any other antenna or transmitter.
3. A label with the following statements must be attached to the host end product: This device contains
FCC ID: XMR2021EM05G
4. To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, maximum antenna gain (including cable loss) must not exceed:
radiation, maximum antenna
gain (including cable loss)
must not exceed: Operating
Band
WCDMA BAND II
WCDMA BAND IV
WCDMA BAND V
LTE BAND 2
LTE BAND 4
LTE BAND 5
LTE BAND 7
LTE BAND 12
LTE BAND 13
LTE BAND 14
LTE BAND 25
LTE BAND 26(814-824)
LTE BAND 26(824-849)
LTE BAND 38
LTE BAND 41
LTE BAND 66
LTE BAND 71
5. This module must not transmit simultaneously with any other antenna or transmitter
6. The host end product must include a user manual that clearly defines operating requirements and
conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to the conditions 3 through 6 described above, a separate approval is
required to satisfy the SAR requirements of FCC Part 2.1093
If the device is used for other equipment that separate approval is required for all other operating
configurations, including portable configurations with respect to 2.1093 and different antenna
configurations.
For this device, OEM integrators must be provided with labeling instructions of finished products.
Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:
A certified modular has the option to use a permanently affixed label, or an electronic label. For a
permanently affixed label, the module must be labeled with an FCC ID - Section 2.926 (see 2.2
EM05-G_Hardware_Design
FCC Max Antenna Gain（dBi） IC Max Antenna Gain（dBi）
7.5
4.5
8.92
7.5
4.5
8.91
7.5
8.2
8.66
8.73
7.5
8.91
8.91
7.5
7.5
4.5
7.98
LTE Standard Module Series
EM05-G Hardware Design
7.5
4.5
7.76
7.5
4.5
7.75
7.5
7.26
7.56
7.63
7.5
NA
7.75
7.5
7.5
4.5
7.12
10 / 69