Table of Contents
Advertisement
2-1. Replacement of Main Parts
2-1-3. Disconnecting/Connecting of Flexible
Card Wire
The two flexible card wires are used between the MB-563
board and CN-1014 board, CN-1049 board.
Be careful not to bend these wires. This shortens the wire
life.
Disconnecting
1. Turn off the power of the camera.
2. Pull out the flexible card wire from the connector.
Wider
Connecting
n
• Be careful not to insert the flexible card wire obliquely.
• Check that the conductive surface of the flexible card
wire is not soiled with dust.
1. Insert the flexible cable tightly into the connector so
that the insulated surface (blue colored) of the cable is
faced to the wider width of the connector flange.
2-2
Flexible card wire
Insulated surface
(Blue colored)
Connector
2-1-4. Installation of Rear Panel
1. Tighten the two screws 1 and 2 in numeral order,
then tighten the other four screws randomly.
2
2-1-5. Replacement of TRIAX Connector
1. Remove the four screws .
Disconnect the connector CN1 on the IO-103 board
and remove the TRIAX connector.
IO-103 board
TRIAX
connector
(Illustration: UC model)
2. Install a new TRIAX connector in the reverse proce-
dures for removal.
1
CN1
PSW3× 6
PSW3×6
CCU-700A(UC)
CCU-700AP(CE)
Advertisement
Table of Contents
