Summary of Contents for Bromic Heating PLATINUM SMART-HEAT MARINE-LR
Page 1
PLATINUM SMART-HEAT™ ELECTRIC HEATER SERIES II (MARINE-LR IP56) BY BROMIC INSTALLATION, INSTRUCTION AND SERVICE MANUAL FOR MODEL 2300W / 3400W IMPORTANT READ THIS MANUAL CAREFULLY. Original Instructions SEE INSIDE COVER FOR IMPORTANT INFORMATION ABOUT THIS MANUAL. KEEP INSTRUCTION WITH APPLIANCE FOR FUTURE REFERENCE.
Page 2
IMPORTANT This manual contains important information about the installation, operation, and maintenance of Platinum Smart-Heat™ Electric Heaters. Please pay close attention to the important safety information shown throughout this instruction manual. Any safety information will be accompanied by the following safety alert symbols: DANGER, WARNING, IMPORTANT...
IMPORTANT NOTES AND WARNINGS WARNING • Be sure the heater is not facing the ceiling or flammable or combustible substances/materials. • IMPORTANT - Installation MUST be carried out by a licensed • This radiant heater shall NOT be installed on recreational vehicles. and authorised person.
IMPORTANT NOTES AND WARNINGS CONTINUED A means for disconnection of the heater must be • Keep the cable away from sharp edges during handling and installation. incorporated in the fixed wiring according to the local electrical codes. • Do not pull on the cable or subject it to traction force. •...
HEATING INSTALLATION INSTRUCTIONS CEILING RECESS KIT INSTALLATION (SOLD SEPARATELY) FOR INFORMATION ONLY • The stated clearance to combustible materials • Heaters must be installed according to the represents surface temperatures of 149 F above ° minimum installation clearances shown in these room temperature.
Page 7
HEATING INSTALLATION INSTRUCTIONS WARNING - Outdoor Installation This heater MUST be permanently installed by an authorised/licenced person. Do not perform maintenance, or carry out installation or assembly procedure while electrical power is switched on. Wait 2 hours after switching off the heater before handling. WARNING - Outdoor Installation It is important that regular maintenance is carried out on the heater to maintain appearance.
Page 8
HEATING INSTALLATION INSTRUCTIONS IMPORTANT BEFORE COMMENCING THE INSTALLATION, PLEASE ENSURE THE BRACKET’S FOAM MATCHES AS PER IMAGE 1. ALL COMPONENTS IN THE BRACKET ASSEMBLY MUST BE USED. THIS PRODUCT IS SPECIFICALLY SUITED FOR CRUISE SHIP INSTALLTION ACCORDING TO INSTRUCTIONS BELOW. NOTE: BRACKET MUST BE FIXED TO VESSEL STRUCTURE.
ELECTRICAL INSTALLATION ELECTRICAL INSTALLATION WARNING This heater MUST be permanently installed by Check product label for correct voltage and an authorised/licenced person. Do not perform wattage to ensure sure power source conforms to maintenance, or carry out installation or assembly the heaters requirements.
AFTER HEATER INSTALLATION PLEASE PHOTOCOPY, COMPLETE, & SEND THIS REPORT BY: BY: FAX TO (02) 9748 4289 or BY MAIL TO Bromic Heating Pty Ltd, 10 Phiney Place, Ingleburn NSW 2565 Australia TO (02) 9748 4289 or BY MAIL TO Bromic Heating Pty Ltd, 10 Phiney Place, Ingleburn NSW 2565 Australia or or SCAN AND EMAIL TO info@bromic.com...