Mira Go Thermostatic Power Shower Installation And User Manual page 15

12. Fit the three rubber feet into the
recesses in the rear of the case
as shown. The feet will reduce the
noise transmitted by the power
shower through the wall.
Warning! Blanking plates should be
fitted to stop water ingress into the
inside of the unit.
13. Fit the blanking plates to the unit
case in the following manner.
For Top Inlet Pipework
For Rear Inlet Pipework
For Bottom Inlet Pipework
Fit the half
blanking plate
to the top of the
case.
Fit the full blanking
plate to the bottom
of the case.
Fit the full blanking
plates to the top
and bottom of the
case.
Fit the full blanking
plate to the top of
the case.
Fit the half
blanking plate to
the bottom of the
case.
15
Rubber Feet
1079321-W2-G