XP Metal Detectors DEUS II Manual page 13

Prg. 7 - DEUS MONO
DEUS MONO works on a single frequency like
There is more likelihood of connecting with an unstable frequency while using several simultaneous fre-
• Ground above your ground effect setting will sound like the
Prg. 8 - GOLD FIELD
GOLD FIELD is intended for highly-mineralized gold-bearing ground. Gold nuggets are often seen as the
ground or ferrous items in these tricky environments. It is set to "all metal" for deeper detection and only
ground above and below your Ground setting.
• Discriminate the surface ferrous items with the IAR Discrimination setting (see Discrimination > IAR).
• Increase the Reactivity when searching strong mineralization for greater stability.
Prg. 9 - RELIC
RELIC is processed in the same way as Prg. 8 - GOLD FIELD, but uses lower subtracted frequencies to
and below this ground setting.
• To search for deep large masses: Sweep well above the ground, e.g. 15 or 20 cm, to avoid being hin-
dered by shallow ferrous items and above all the ground effects that may distort deeper signals. You will
then be able to identify deep masses by the longer sounds. Depending on the ground and your patience,
reducing the Reactivity to 0 will offer a huge advantage in order to gain greater depth.
Prg. 10 - DIVING
DIVING
or simply on wet sand. Its very low and medium subtracted frequencies will better locate valuable targets
such as rings and coins, whilst naturally being less responsive to low conductive targets like aluminum
foil compared to the more sensitive Beach 11 and 12 programs. It can thus save time and be more effective
• Do not hesitate to activate B.Caps if there are troublesome rusty ferrous caps.
• Select an inland program preferably for fresh water diving.
Prg. 11 - BEACH
BEACH uses higher frequencies up to 24 kHz and thus is more sensitive to small targets compared to
Diving. It is well suited to wet zones.
• Sweep parallel without raising the coil at the end of each pass. If you can not maintain an even sweep
and notice instability, you can reduce Salt sens (see Menu) to reduce the Salt water sensitivity.
• Increase the Reactivity if you experience instability or pollution.
• Do not hesitate to activate B.Caps if there are troublesome rusty ferrous caps.
• Beach can also be used while diving but the response may be more unsettled.
Prg. 12 - BEACH SENS
BEACH SENS incorporates frequencies up to about 40 kHz offering excellent sensitivity to the smallest
targets without loosing performance on bigger targets. This is the deepest beach program for wet condi-
tions but also the most reactive.
• Sweep parallel without raising the coil at the end of each pass. If you can not maintain an even sweep
and notice instability :
- Reduce Salt sens (see Menu) to reduce the Salt water sensitivity.
- Increase the Reactivity to 1, 2 or 2.5.
- Reduce the Audio Response.
• Activate B.Caps if there are troublesome rusty ferrous caps.
FACTORY PROGRAMS
1, but combines the advantages of DEUS II, such as
FMF • Max. freq. 40khz • Frequency addition
FMF • Max. freq. 24khz • Frequency subtraction
FMF • Max. freq. 14khz • Conductive soil subtraction
FMF • Max. freq. 24khz • Conductive soil subtraction
FMF • Max. freq. 40khz • Conductive soil subtraction
13