Factory Programs - XP Metal Detectors DEUS II Manual

FACTORY PROGRAMS

has the advantage of offering a wide range of programs suitable for all ground and search condi-
high and low frequency combinations depending on the programs. For example, some use low to medi-
um frequencies e.g. 4 to 14 kHz and other programs include higher frequencies up to 24 kHz or 40 kHz.
best possible way. These frequencies can then be subtracted to remove electrically-conductive soils or
added together to help locate a wider range of targets. The processing platform information used for each
program is displayed in the title bar. Read the data for each program carefully to get the most out of your
!
(See also the comparison table at the end of the manual to better understand the different parameters
each program has to offer).
Prg. 1 - GENERAL
GENERAL uses low and high frequencies and gives an excellent assessment of targets in the soil. It suits
both beginners and experienced users.
It offers an excellent target/false signal ratio in the ground,
dence on deep targets. This damp / wet soil subtraction thus attenuates the very low electric conductors
like coke (coal, and conductive stone) and to a lesser extent certain very thin targets like aluminum foil.
• Very effective, test it in the soil, not in the air.
Prg. 2 - SENSITIVE
SENSITIVE
effective in mineralized and polluted ground when searching for the smallest targets.
accuracy than with a mono-frequency metal detector. A very narrow notch zone is thus activated within
frequencies 23 to 25 (see Notch > Expert)
eralized ground.
Prg. 3 - SENSI FT
SENSITIVE FULL TONES
cation that requires a little more experience, as each target index generates a different tone in proportion
Prg. 4 - FAST
FAST is based on the same platform as Prg. 2 - SENSITIVE, but the audio is set to Pitch mode with Re-
activity at 3 instead of 2.5 and uses the square audio feature. These three settings combined allow the
machine to work fast in ferrous-polluted and mineralized ground.
Prg. 5 - PARK
PARK
are normally polluted.
Prg. 6 - DEEP HC
DEEP HIGH CONDUCTOR
Designed to better locate good conductivity targets, it is ideal for clusters of coins whilst maintaining ex-
cellent sensitivity to isolated coins using its 14 kHz frequency.
• Ground Stability is set to 1 and soils above your setting will therefore sound to provide you with the
12
FMF • Max. freq.
FMF • Max. freq.
FMF • Max. freq.
FMF • Max. freq.
FMF • Max. freq.
FMF • Max. freq.
adds together very low and medium frequencies up to 14 kHz.
40khz • Conductive soil subtraction
40khz • Frequency addition
40khz • Frequency addition
40khz • Frequency addition
24khz • Frequency addition
14khz • Frequency addition
uses different
-
very
-
-