C-TEC CAST XFP Engineering Manual page 20

CAST XFP 16 ZONE ANALOGUE ADDRESSABLE FIRE ALARM PANEL
SETUP PASSWORDS
This function allows you to change the access codes required to enter the panel's access level 2 or 3
menu options.
Enter AL3 (4444) > Setup Passwords.
When selected, press the Accept
CHANGE ACCESS LEVEL 2 CODE?
Change Access Level 3 code
5 6
Press the and buttons to scroll to the desired option and press the Accept
message will appear if the CHANGE ACCESS LEVEL 2 CODE prompt is selected:
Enter NEW Access Level 2 code:
5 4
Using the (1)
digit has been entered, the panel will request you confirm the new code by re-entering it.
Enter NEW Access Level 2 code:****
Confirm New Access Level 2 code:
Enter the code again by pressing the
match, the new code will be accepted. If you type an incorrect confirmation code, you will be prompted
to start the code entry sequence again. The same process can be used to change the access level 3 code.
BE SURE TO KEEP A RECORD OF ANY CHANGED CODES FOR FUTURE USE.
CONNECT TO PC
This function allows you to activate the panel's PC connection for system programming purposes. The
panel's cause and effects programming, device and zone naming, zone dependency functions, etc.,
MUST be done using panel's PC programming tools (Part No. XFP507).
Enter AL3 (4444) > Connect to PC.
When the CONNECT TO PC prompt appears, press the Accept
the following message will appear:
PC connected...
Press ESC to disconnect from PC
ENGINEERING MANUAL • Approved Document No. DFU5010000 Rev 4 • Page 20 of 48
4
button and the following window will appear:
6 3
(2) (3) (4) buttons, enter the new four digit access level 2 code. After the fourth
5
(1)
4 6 3
(2) (3) (4) buttons in same sequence. If the two codes
4
4
button. The following
button. If all connections are correct,