A Detailed Description Of The Functions Available At Access Level 3 - C-TEC CAST XFP Engineering Manual

CAST XFP 16 ZONE ANALOGUE ADDRESSABLE FIRE ALARM PANEL
A detailed description of the functions available at access level 3 can be found below.
DISPLAY FIRE EVENTS
This function is only available if there are active fire conditions on the system.
Enter AL3 (4444) > Display Fire Events.
If available, press the Accept
Last Zone: 1:North Stairs
5
Pressing the and
information can be viewed by pressing the panel's More Information button.
DISPLAY FAULT EVENTS
This function is only available if there are active faults on the system.
Enter AL3 (4444) > Display Fault Events.
If available, press the Accept
Zone 1: Ground Floor
There are faults on this zone
5
Pressing the and
can be viewed by pressing the panel's More Information button.
DISPLAY DISABLEMENTS
This function is only available when there are active disablements on the system.
Enter AL3 (4444) > Display Disablements.
If available, press the Accept
Zone 1: Shop floor
On: This Panel: Is Disabled
5
Pressing the and
DISPLAY ZONES IN TEST
This function is only available if one or more zones are being tested.
Enter AL3 (4444) > Display Zones in Test.
If available, press the Accept
Zone 1: North Stairs
Is On Test
5
Pressing the and
ENGINEERING MANUAL • Approved Document No. DFU5010000 Rev 4 • Page 19 of 48
4
button and a window similar to the one below will appear:
:Fire!
1 Zone
6
buttons will scroll the display through all active fire conditions. More detailed
4
button and a window similar to the one below will appear:
6
buttons will scroll the display through all active faults. More detailed information
4
button and a window similar to the one below will appear:
6
buttons will scroll the display through all active disablements.
4
button and a window similar to the one below will appear:
6
buttons will scroll the display through all zones currently in test.