Sensata Dimensions 12LP15 Owner's Manual page 13

DC Wire Gauge & Fusing Continued
Typical Cable Connection Procedure
NOTE: Refer to Figure 4 for a typical DC wiring diagram. See Table 2 for proper cable sizes.
1. Remove the fuse from the fuse holder.
2. Connect the inverter's bonding lug to ground of the vehicle chassis.
3. Connect the ring terminated end of the black inverter cable set directly to the negative (-) side of the battery
bank at a negative battery post.
4. Connect the fuse holder to the positive (+) side of the battery bank.
5. Connect the ring terminated end of the red inverter cable set directly to the fuse holder.
6. Install the fuse in the fuse holder. A typical one-time spark will occur when this final connection is made.
7. Install the fuse holder cover.
Figure 4 Typical DC Wiring Diagram
Page 13
12LPC15 Manual