Canopy Removal; Installing The Battery Packs - ProBoat UL 19 Hydroplane Owner's Manual

30-inch brushless rtr
Hide thumbs Also See for UL 19 Hydroplane:
Table of Contents

Advertisement

Canopy Removal

1.
Loosen the 4 screws located at each
corner of the canopy.
2. Remove the canopy from the hull start-
py
ing with the 2 rear screws. Ensure that
the 2 rear screws. Ensure that
the 4 screws have disengaged from
ews have disengaged from
their bases before carefully lifting the
es before carefully lifting the
canopy.

Installing the Battery Packs

The included electronics are rated for 2S–6S LiPo
batteries; however, running the stock propeller nonstop
on a 6S battery could overheat your electronics or
damage your batteries. If you run the stock propeller on
6S, we recommend using full throttle on straight line
passes only. Return passes should be at half throttle to
reduce the heat of the electronics. If you want to run 6S
nonstop, use optional propeller (PRB282028).
1.
Install the 2 battery packs on the left and right sides of
the boat hull. Secure the batteries with the included
hook and loop straps. When running your boat in
rough water, use Waterproof Hook and Loop Tape
(DYNK0300) between the batteries and the battery
tray to secure the batteries more fully.
Tip: Start with the batteries as far forward as possible,
moving them 1/4 inch at a time toward the bow until your
boat reaches maximum speed.
2. Connect each battery pack to the ESC power connec-
tors.
The included propeller provides the best performance
between 4S (14.8V) and 5S LiPo (18.5V). 5S configuration
can be achieved by mounting a 3S LiPo battery
(DYNB3811EC) on the left side of the boat and a 2S LiPo
battery (DYNB3810EC) on the right side of the boat.
The added weight of the 3S battery on the left side will
counteract torque twist caused by the propeller spinning
at high RPM.
30 - INCH READY - TO - RUN BRUSHLESS BOAT
X2
WARNING: When using 2 batteries in series, always
make sure they are in roughly the same condition
(age) and they have the same capacity (mAh) and discharge
rate (C rating). Failure to do so may cause damage to your
batteries, potentially causing a fire.
EN
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prb08028v2

Table of Contents