Boat Stand Assembly; Antenna Tube Installation; Canopy Removal - ProBoat Blackjack 29 PRB08011 Owner's Manual

Boat Stand Assembly

1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the side
stand to the ends.
3. Allow the adhesive to dry before placing your boat on
the stand.

Antenna Tube Installation

1. Carefully feed the end of the receiver antenna through
the grommet inside the hull.
2. Pull the antenna wire out of the grommet
towards the outside of the boat, then slide the
antenna through the antenna tube.
3. Insert the tube into the grommet, then
fit the cap onto the tube.
4. Apply clear tape to the antenna, grommet
and hull in the boat to keep the antenna
from moving.
The antenna must be installed above the boat's waterline
to get the best reception of your transmitter's signal.
NOTICE: Do not cut or kink the receiver antenna
or damage may result.

Canopy Removal

1. Push down and turn the latch button one quarter of a
turn to disengage the pin from the hull.
2. Carefully lift the rear of the canopy and pull back to
disengage the front pin from the hull.
Blackjack 29
EN
5