Table of Contents
Advertisement
EN
Transmitter Functions
Specifications
Power Supply: 4 AA Batteries
Operating Frequency: 2.4GHz
Transmit Power: <100mw
Control Protocol: SLT
Control: Proportional Steering and Throttle/Brake with Trim Knobs, Third Channel
with 3 Position Momentary Switch
Auxiliary Functions: 3 Position Throttle Limit Switch, Steering Rate Knob to
Change Steering Travel on-the-fly, Programmable Servo Travel for Steering and
Throttle/Brake
1.
Throttle Trim
Adjusts the throttle neutral point
2. Steering Trim
Adjusts the steering center point. Normally, the steering trim is adjusted until the
vehicle tracks straight.
3. LED
•
Solid red lights: Indicates the power is ON and adequate battery power
•
Flashing red lights: Indicates the battery voltage is critically low. Replace
batteries
4. Steering Wheel
5. Throttle/Brake
6. Steering Rate
On-The-Fly knob for travel adjustment on the steering
7 .
Channel 3
3 position momentary switch, middle position is neutral
For programming press up for A button, press down for B button
8. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are driving the
vehicle in a small area.
9. Throttle (TH) Servo Reversing
Move the switch to reverse the throttle channel
10. Steering (ST) Servo Reversing
Move the switch to reverse the steering channel
11. Power Button
Installing the Transmitter Batteries
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION: If using rechargeable batteries, charge only rechargeable batteries. Charging non-rechargeable batteries may
cause the batteries to burst, resulting in injury to persons and/or damage to property.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to national
regulations.
Factory Reset
There is a hidden mode if you want to reset the servo travel and calibration in the transmitter.
1.
Hold full left and full brake while powering the transmitter ON to put the transmitter into programming mode.
The LED will fl ash 4 times then turns OFF to indicate factory reset.
2. Release the wheel and throttle trigger back to neutral and the LED will illuminate to indicate factory reset is com-
plete.
3. Power the transmitter OFF .
6
A. A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
UL 19 Hydroplane
Advertisement
Table of Contents
