After Boating And Maintenance; Motor Care; Water Cooling System - ProBoat UL 19 Hydroplane Owner's Manual

After Boating and Maintenance

• Drain water from inside the hull using the drain plug
• Fully dry the inside and outside of the boat, including
the water cooling lines and jacket around the motor.
Remove the hatch before storing your boat
• Repair any damage or wear to the boat
• Lubricate the fl ex shaft using Pro Boat Marine Grease
(DYNE4200)
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions
Tip: The hook and loop strips in the boat retain water. To
dry them, press on them with a dry cloth.

Motor Care

• Prolong motor life by preventing overheating
conditions. Undue motor wear results from frequent
turns, stops and starts, pushing objects, boating in
rough water or vegetation and boating continuously at
high speed.

Water Cooling System

If water does not stream out of the water outlets
while the boat is moving forward, immediately
return the boat to shore and clean any obstructions
or remove kinks from the water cooling lines/
system.
1. Disassemble and clean the water cooling system
to remove blockage and prevent overheating.
2. Replace damaged parts.
30 - INCH READY - TO - RUN BRUSHLESS BOAT
NOTICE: When you are finished boating, never leave the
boat in direct sunlight or in a hot, enclosed area such as a
car. Doing so can damage the boat.
• Over-temperature protection is installed on the ESC to
prevent circuit damage, but cannot protect the motor
from excessive physical resistance.
EN
11