Boat Stand Assembly; Canopy Removal; Propeller Installation; Rudder Installatiton - ProBoat Rockstar 48 Owner's Manual

EN

Boat Stand Assembly

1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the side
stand to the ends.
3. Allow the adhesive to dry before placing your boat on
the stand.

Canopy Removal

1. Push down and turn the 2 knurled pins one quarter of
a turn to disengage the pins from the hull.
2. Carefully lift the rear of the canopy and pull back to
disengage the front pin from the hull.

Propeller Installation

1. Correctly align the propeller with the drive dog on the
prop shaft.
2. Tighten the nut on the prop shaft.
3. Disassemble in reverse order.
Tip: Propeller balancing can add several mph to top
speed and reduce vibration. There are several different
propeller balancing tools available. Read the instructions
that accompany the propeller balancing tool, as removing
material from the correct part of the propeller is crucial.
Rudder Installation
1. Install the rudder in the mount using 2 screws and 2
locknuts as shown.
2. Connect the tube from the back of the boat to the
barbed fitting on the top of the rudder.
4 RockStar 48