Additional Required Items; Suggested Field Equipment And Supplies; Contents; Section 1: Building The Boat Stand - ProBoat Blackjack 55 Owner's Manual

Additional Required Items

™
Although the Blackjack 55 comes fully assembled and ready for action, you will need a few additional items
in order to run your boat. You will need the following:
Zenoah ® 2-Cycle Oil (ZEN20001)
Flex Shaft Lubrication (PRB0100)
Fuel Pump (HAN155)
12 AA Alkaline Batteries (8 for the transmitter and 4 for the receiver)

Suggested Field Equipment and Supplies

In addition to the items needed to run the Blackjack 55, we recommend that you carry the following in your
field box:
Engine Tuning Screwdriver (DYN2775)
Bronze Alloy Propeller (PRB0153)
2.5mm Hex Wrench
#1 Phillips Screwdriver
Wax
• Assembled Blackjack 55 RTR
• JR ® XR3i radio transmitter
• Boat stand
• Rudder (2)
CA or Epoxy Glue
Fuel Container
Gasoline (+87 Octane), Ethanol-ree
Clean Towels
2mm Hex Wrench
4mm Hex Wrench
Small Crescent Wrench
Screw-locking Compound

Contents

 

Section 1: Building the Boat Stand

m 1. There are 4 plywood boat stand pieces. The
2 short plywood pieces are the ends of the boat
stand.
m 2. Secure the 2 long plywood pieces of the
interlocking boat stand to one end of the short
plywood pieces. Repeat with the remaining short
plywood pieces.
m 3. Secure the stand together where each piece is
joined with epoxy or CA glue (not included).

Section 2: Removing the Canopy

m Unscrew the 2 knurled hatch-mounting screws
from the rear of the hatch. Slide the front hatch
retainer toward the rear of the boat and lift the
hatch from the boat.