Table of Contents
Advertisement
EN
Boat Stand Assembly
1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the
side stand to the ends.
3. Allow the adhesive to dry before placing your boat
on the stand.
Canopy Removal
1. Loosen the 4 screws located at each
corner of the canopy.
2. Remove the canopy from the hull starting
with the 2 rear screws. Ensure that the 4
screws have disengaged from their bases
before lifting the canopy carefully.
Propeller Installation
1. Correctly align the propeller with the drive dog
on the prop shaft.
2. Tighten the nut on the prop shaft.
3. Disassemble in reverse order.
Tip: Propeller balancing can add several mph to
top speed and reduce vibration. There are several
different propeller balancing tools available. Read
the instructions that accompany the propeller
balancing tool, as removing material from the
correct part of the propeller is crucial.
Rudder Installation
1. Install the rudder in the mount using 2 screws
and 2 locknuts as shown.
2. Connect the tube from the back of the boat to
the barbed fitting on the top of the rudder.
4
Zelos™ 48-Inch Gas Catamaran
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
