Spmsr315 Dual Protocol Receiver; Receiver Antenna; Binding To Slt - ProBoat UL 19 Hydroplane Owner's Manual

EN

SPMSR315 Dual Protocol Receiver

Specifications
Type: Dual Protocol 3 Ch Receiver* (SLT/DSMR)
Dimensions (LxWxH): 32.5 x 21.5 x 12.4mm
Antenna Length: 90mm
Channels: 3
Weight: 6g
Band: 2.4GHz
Voltage Range: 3.5–9.6V
Bind Type: Bind Button
Failsafe: Hold the steering wheel and throttle trigger in the desired failsafe positions during
binding
• SPMSR315 receivers included with the SLT3 transmitter include SLT and DSMR compatibility.
If you have an SR315 receiver that was purchased by itself, you may need to install a fi rmware
update to make your SR315 SLT compatible.

Receiver Antenna

The SR315 receivers feature a coaxial antenna design for easy installation in almost any model. Think of the last 1
inch (32mm) on the tip of the antenna as the active portion of the antenna, the coaxial portion leading up to it is just
an extension. Install the antenna so the active portion is positioned as high as possible in the vehicle, and not "in the
shadow" of any carbon fiber or metal. The case of the receiver can accept an antenna tube directly, making optimal
antenna placement easy (antenna tube not included).
WARNING: Do not kink, cut or damage the antenna wire. The antenna is made of a coaxial wire; if the outer sheath
becomes damaged, the receiver will not work properly. If the antenna is damaged in any way, replace the antenna
before attempting to use the receiver.

Binding to SLT

Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of a
single specific transmitter.
1. Power ON the receiver, press the bind button three
times quickly (within 1.5 seconds of the fi rst button
press). The LED will begin to fl ash with a pause.
2. Set the trims and control positions at the desired failsafe
settings, and power ON the SLT3 transmitter.
3. When the LED on the SLT3 transmitter and receiver
remain lit, binding is complete.
You must rebind when:
• Different failsafe positions are desired e.g., when throttle
or steering reversing has been changed.
• Binding the receiver to a different transmitter.
Binding to DSMR/DSM2
If loss of signal occurs, SmartSafe™ technology moves
the throttle channel to its designated failsafe position (low
throttle) that was set during binding. All other channels hold
their last position. When the receiver detects signal from
the transmitter, normal operation resumes.
Binding Procedure
1. Push and Hold Bind Button
2. Power on Reciever
3. Release Button after RX goes into Bind Mode (fl ashing
LED)
4. Place transmitter in Bind Mode and fi nish Binding.
8
Failsafe
In the unlikely event that the radio connection is lost
during use, the receiver will drive the servos to their pre-
programmed failsafe positions as set during Binding.
If the receiver is powered on before powering on the
transmitter, the receiver will enter this failsafe mode. When
the transmitter is powered on, normal control is resumed.
IMPORTANT: Failsafe activates only in the event that signal
is lost from the transmitter. Failsafe will NOT activate in
the event that receiver battery power decreases below the
recommended minimums or power to the receiver is lost.
BATT
STR THR AUX 1
Bind Button
UL 19 Hydroplane