EdilKamin PELLKAMIN 12 Installation, Use And Maintenance Manual page 6

Example of minimum recommended dimensions for installation with fans at the bottom and
optional stand at minimum height. This example for illustrative purposes only. Holes should
also be made for: the fume discharge (flue); the combustion air inlet; ventilation air recovery (a 10x10 cm hole in the
side of the covering)
30/40
*
6
*
Do not exceed the height of the base with the cladding. This is so that the maintenance technician can slide
the appliance out on its rails during maintenance work.
Legend
A = hole for pellet loading trapdoor (on the side, can also be installed on the front)
B = hole for fan housing (on the side at the bottom)
C = hole for compensation vent
D = hole for the product
E = hole for the vents (Split/Bent/Origami/Sharp)
F = hole for ventilation air recovery (a 10x10 cm hole in the side of the cladding)
MEASUREMENTS (cm) OF HOLES ON PLASTERBOARD
Fan housing
Vents (Split/Bent/Origami/Sharp)
Label Vents
Pellet loading trapdoor
Hole for ventilation air recovery
The drawing represents the version with trapdoor loading and ducted ventilation
The pellets can be loaded even when the fire is burning.
Also estimate a space for the simplified ignition button.
NOTES ON DIMENSIONS
18.5
A
B
F
20
70
19 x 20
15 x 15
87.5 x 4
31 x 21
10 x 10
15
E
E
88
87.5
150
C
C