Table of Contents
Advertisement
Installing the VSP 4450GTX-HT-PWR+
Environmental requirement
Miscellaneous Operating
Considerations
Warning:
To avoid bodily injury from hazardous electrical shock and current, never remove the top of the
device. No user-serviceable components are inside. For a translation of this statement, see
Translations of safety messages
Airflow direction
The airflow direction in the VSP 4450GTX-HT-PWR+ for the top half of the switch, where the
components exist, is from left to right (as viewed from the front). Cool air enters the chassis through
an air inlet at the left of the chassis, which cools the device. Warm air exits through the exhaust at
the right.
The airflow direction for the bottom half of the VSP 4450GTX-HT-PWR+, where the power supplies
exist, is from front to back. The chassis draws in cool air from the front of the chassis, and hot air
exits at the rear.
Package contents
The following describes the components that are provided with each switch. If any components are
missing, contact the switch vendor.
1. VSP 4450GTX-HT-PWR+ switch with one power supply installed
2. Rack-mounting hardware that includes:
• Rack-mount brackets
• Screws to attach brackets to the switch
• Screws to attach the switch to the equipment rack
August 2018
Virtual Services Platform 4000 models
• No heat sources such as hot air vents or direct sunlight near the
switch.
• No sources of severe electromagnetic interference near the switch.
• No excessive dust in the environment.
• An adequate power source is within 6 feet (1.83 meters) of the switch.
One 15-amp circuit is required for each power supply.
• At least 2 inches (5.08 centimeters) of clearance on each side of the
switch unit for ventilation.
• Adequate clearance at the front and rear of the switch for access to
cables.
on page 39.
Installing the Virtual Services Platform 4450GTX-HT-PWR+
20
Advertisement
Table of Contents
