Chapter 4: Preinstallation Checklist - Extreme Networks ExtremeSwitching Virtual Services Platform 4450GTX-HT-PWR+ Installation Manual

Chapter 4: Preinstallation checklist

Before you install the VSP 4450GTX-HT-PWR+, make sure that you complete the tasks in the
preinstallation checklist.
No. Task
1. Review the technical specification for
the switch. Make sure that the area
where you install the switch and where
it will operate meet the requirements.
2. Verify the power supply unit (PSU)
specifications. Optionally order a
redundant PSU to provide redundancy
and load sharing.
3. Make sure that you have the following
tools and cables:
• Phillips #2 screwdriver
• RJ45 console port cable
• ESD cable
4. Unpack the equipment.
5. Verify the contents of the shipped
package.
6. Make sure that the power cord has the
correct country-specific termination.
7. Prepare the rack.
August 2018 Installing the Virtual Services Platform 4450GTX-HT-PWR+
Description
For the physical, electrical, and environmental
specifications, see Technical specifications
page 19.
See AC power supply specifications
page 29.
To order redundant PSUs, see
models on page 10 for part numbers.
See Cable requirements for the VSP 4000
page 24.
Observe ESD precautions when you unpack
the equipment. See Electrostatic discharge
page 17.
See Package contents on page 20 for a
description of the components that are
provided with the switch. If any components
are missing, contact Extreme Networks
support.
Ensure that there is enough rack space to
accommodate a 2RU switch (8.8 cm).
Ensure that the rack is bolted to the floor and
braced if necessary.
Ensure that the rack is grounded to the same
grounding electrode used by the power service
on
on
Hardware
on
on
Table continues...
14