App-B Technical Specifications - Powercom Line-Interactive 1025AP User Manual

If troubleshooting does not include or resolve your situation, feel free to
contact for technical assistance.
PROBLEM
UPS can't operate
switching on.
No lights on,
no warning sound
UPS always remain on
battery-mode regardless of
main power connection
Overload/Fault indicator lit
or constant buzzer beeping
Battery mode duration
below expectation
The battery fault indicator
occurred
Model
Configuration
Capacity (VA)
Capacity (Watts)
Form
Input
Voltage
Input Voltage Range
Input Frequency Range
Output
Waveform(Battery-Mode)
Voltage
© All rights reserved. All trademarks are property of their respective owners.
POSSIBLE CAUSE
Power source mistake or low
battery power
Time of pressing the button is
too short
Output short circuit or overload
on UPS
Hardware failure
Battery out of order
No power source input
Fuse melted or Circuit breaker tripped
The main voltage is out of the
UPS input range
UPS load exceed the capacity
UPS overloading
Batteries aren't fully charged
Batteries are worn out or faulted
The charger is out of order
Green mode enabled
No-load or light load shutdown engaged
Battery not connected
Battery out of order or damaged

APP-B Technical Specifications

1025AP
1025 VA
615 W
Check for any potential internal short circuit
Replace battery or contact for technical assistance
Check the main power source and cable
(spare fuse is in UPS inlet.) then restart the UPS
Remove or shut down the less essential load
Run a self-test to check battery status
Replace UPS battery if the problem remains
Turn off green mode to disable such function
1200AP 1500AP
1200 VA 1500 VA
720 W 900 W
Tower Type
100 / 110 / 120 VAC or 220 / 230 / 240 VAC
75 - 150 or 165 - 300 VAC
50 Hz / 60 Hz (Auto Sensing)
Simulated Sine Wave
100 / 110 / 120 VAC or 220 / 230 / 240 VAC
9
Solutions
Check the main power connection
If operating with battery power,
ensure enough charging time for UPS
Press and hold the "ON" button for
a longer duration
Turn off UPS and take off all load
Then attempt to turn on UPS again
Contact for technical assistance
Reset the breaker or replace the fuse
UPS function normally,
check your main power voltage
Ensure enough recharge time for UPS
Contact for technical assistance
Operation normal
Check the UPS batteries;
make sure they are well connected
Replace battery
2000AP
2000 VA
1200 W
3000AP
3000 VA
1800 W