App-B Technical Specifications - Powercom 425A User Manual

Overload/Fault indicator lit
or constant buzzer beeping
Battery mode duration
below expectation
The battery fault indicator
occurred
Model
Configuration
Capacity (VA)
Capacity (Watts)
Form
Input
Voltage
Input Voltage Range
Input Frequency Range
Output
Waveform(Battery-Mode)
Voltage
Frequency(Battery-Mode)
Transfer Time
Protection
Full Protection
Tele Communication
Battery
Type
Quantity
Typical Recharge Time
Management & Communication
Indicator
Communication Port
Physical
Dimensions (WxDxH) (mm)
© All rights reserved. All trademarks are property of their respective owners.
UPS load exceed the capacity
UPS overloading
Batteries aren't fully charged
Batteries are worn out or faulted
The charger is out of order
Green mode enabled.
No-load or light load shutdown engaged
Battery not connected
Battery out of order or damaged

APP-B Technical Specifications

425A/AP 525A/AP
425 VA
255 W
12V 7.2Ah
Remove or shut down the less essential load
Replace UPS battery if the problem remains
Turn off green mode to disable such function
625A/AP
525 VA 625 VA
315 W 375 W
Tower Type
100 / 110 / 120 VAC or 220 / 230 / 240 VAC
75 - 150 or 165 - 300 VAC
50 Hz / 60 Hz (Auto Sensing)
Simulated Sine Wave
100 / 110 / 120 VAC or 220 / 230/ 240 VAC
50 Hz / 60 Hz ± 0.5 Hz
2 - 4 ms (Typical)
Overload, Surge, Short Circuit
RJ11 / RJ45 : AP model
1
6-8 hr to 90%
LED Control Panel : IMP model
Digital Control Panel : IMD model
USB B type : AP model
105 x 334 x 168
9
Ensure enough recharge time for UPS
Run a self-test to check battery status
Contact for technical assistance
Operation normal
Check the UPS batteries;
make sure they are well connected
Replace battery
825A/AP
825 VA
495 W
12V 9 Ah
1000A/AP
1000 VA
550 W
1