Residual Risks; Assembling Instructions; Assembling The Handle Bar - Parkside PLVA 40-Li A1 Translation Of The Original Instructions

GB IE
Electrical safety:
CAUTION! The following states
how to avoid accidents and
injuries due to electric shock:
• Avoid body contact with
earthed parts (e.g. metal fences,
metal posts). There is an in-
creased risk of electric shock if
your body is earthed.
• Do not expose electric tools to
rain or wet conditions. The pen-
etration of water into an electric
tool increases the risk of electric
shock.
• Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric
shock or fire.
Observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual for
your battery and char-
ger from the Parkside
X 20 V Team series. A
detailed description of
the charging process
and further informati-
on can be found in the
separate operating inst-
ructions.

Residual Risks

There will always be residual risks
even if you operate this electrical
tool according to the instructions.
The following hazards may occur in
connection with the type and design
of this electric tool:
30
a) a) Cutting injuries
b) Hearing damage if suitable ear
protection is not worn.
c) Health injuries resulting from the
effect of vibration on the hands
and arms in the event that the
device is used over a longer pe-
riod of time or is not used and
maintained properly.
Warning! During operation,
this power tool produces an
electromagnetic field. Under
certain circumstances, this
field may negatively affect
active or passive medical
implants. In order to reduce
the danger of serious or fatal
injuries, we recommend that
individuals who wear medi-
cal implants should consult
their doctor and the manu-
facturer of the implant before
operating the machine.

Assembling instructions

Always pull the ignition key (
and remove the batteries before
working on the device.
Ensure during assembly that the
machine cable (
squeezed and that it has sufficient
play.
Assembling the
B
handle bar
1. Attach the lower bar (6) to the appli-
ance housing (9) and fasten it using
the two quick-release levers and wash-
ers (7). The smooth side of the washer
should point towards the quick-release
21)
15) is not
A