Mounting And Emptying; The Collection Bag; Operation; Setting The Working Positions - Parkside PLVA 40-Li A1 Translation Of The Original Instructions

Cordless scarifier/aerator
Hide thumbs Also See for PLVA 40-Li A1:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22
lever; the grooved side should point
towards the device.
2. Screw both central bars (5) with the
screws, quick-release levers and wash-
ers (4) to the lower bar (6). The smooth
side of the washer should point towards
the quick-release lever; the grooved
side should point towards the device.
3. Screw the upper handlebar (3) with
the screws, quick-release levers and
washers (4) to both central bars (5) to
fasten.
4. Fasten the machine cable (15) to the bar
using the machine cable terminals (11).

Mounting and emptying

C

the collection bag

WARNING: Never operate the
implement without the impact
protector. Danger of Injury!
The collection bag is recommended
for operation with the air roller
(
17)!
A
1. Pull the collection bag over the rods.
2. Put the plastic straps of the collection
bag over the collection bag rods and
clip into the plastic straps.
Mounting the collection bag on the
implement:
3. Lift the impact protector (14).
4. Push the pins on the collection bag rods
into the socket in the implement case.
5. Release the impact protector so that it
holds the collection bag (12) in its posi-
tion.
Removing and emptying the collec-
tion bag:
6. Lift the impact protector (13) and take
out the collection bag (12).

Operation

Please observe local regulations
concerning noise protection.
Setting the working posi-
tions
The implement has 5 principal position
settings:
+10 mm :
Transport position
This position sets the maximum safety
spacing between the tool and the floor.
-3 mm :
Working position
Set this position when working with a new
implement.
-3 to -12 mm : Readjustment
The working position can be lowered with
increased knife and sprung tine wear.
Wear can be identified from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
When the implement is deliv-
ered it is in the Transport Position
(+10 mm) setting.
1. The implement must be switched off to
set the working position.
2. Adjust the depth adjustment lever
(
11) and allow it to lock into place
A
in the desired position.
Selection of a readjustment position
without the corresponding wear
can overload the motor and dam-
age the cylinder.
GB
positions
IE
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

304403 1904

Table of Contents