Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd.
Start Touchlink
6.6 HEX Parameter description
System transmitting mode
6.6.1
mode：
0x00 Broadcast（default）；
address in configuration mode);
address in configuration mode);
short address of the target device network);
number);
6.6.2 Receiving data output mode
mode：
Note: the maximum package length is 72
6.6.3 Network node type
dev_type：
0x01 Coordinator
0x02 Router
0x03 End-device (default)
0x04 Sleep-End-device
Changing the configuration of a node type takes effect after restart. If node type device is configured in normal
operation, it will leave the current network in a no-network state. After the restart, it will switch to the changed node
type. The sleep-end-device supports the serial port receive pin wake-up function. The wake-up frame byte length is
greater than or equal to 25 bytes. It is recommended to use "FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
FF FF FF FF FF FF FF FF FF "25 bytes of "FF" wake up.
Network state
6.6.4
nwk_state：
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co.,Ltd.
Send：F5 01 40 04 FF
Return：FC 40 00
0x01 (need to configure the target group number in configuration mode first);
0x02 Transparent transmission on demand + short address (need to configure the target short
0x03 transparent transmission on demand + long address (need to configure the target long
0x04 protocol on demand + short address (the first two bytes in the transmission mode are the
0x05 protocol multicast (the first byte in the transmission mode is the target network group
0x00 transparent transmission（default）；
0x01 data+short address；
0x02 data+long address；
0x03 data+RSSI;
0x04 data+short address+RSSI；
0x05 data+long address+RSSI
；
E180-ZG120B User Manual
Send：F5 01 40 04 FF
Return：FC 40 00
22
Advertisement
Table of Contents
