Ebyte E180-ZG120B User Manual page 17

Chengdu Ebyte Electronic Technology Co.,Ltd.
Output mode Read/Write
Remote
configuration
Read/Write
ID
Local network
Read/Write
group number
Target network
Read/Write
group number
Wake-up period
Read/Write
(sleep time)
Network
Read/Write
opening time
Lost parent node
reconnection Read/Write
period
Maximum
number of
Read/Write
reconnections
IO state Read/Write
PWM Read/Write
ADC value
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co.,Ltd.
the corresponding mode function introduction;
The data output mode is:
Transparent transmission;
Data + short address;
0、1、2、3、
Data + long address;
4、5
Data + RSSI;
Data + short address + RSSI;
Data + long address + RSSI;
It is used to determine whether the data received by the air in the
air is a remote configuration command. The customer can change
2 byte
the unlimited configuration ID according to the requirements. The
default is A8 8A;
Used to configure the device number of the device in network;
0～255
Group number corresponding to the target when configuring device
0～255
multicast;
It is used to configure the wake-up cycle of the end-device sleep device.
0～2010s The larger the cycle is, the lower the overall power consumption is, but
the greater the delay of receiving data is;
It is used to configure the opening and closing of network security.
10～2540s During the opening period, the device can join the network, and during
the closing period, the device cannot join;
1～255 When the parent node is lost (the coordinator is powered down), the end-
minutes
device reconnects the previous network at regular intervals;
After the parent node is lost, the maximum number of
1 to 255 reconnections, if it has not been reconnected successfully, clears
times the previous network information, rescans the new network, and
the scanning period is equal to the reconnection period;
Access/control module level status of the GPIO channel;
High/Low
Access/control module duty cycle and period of the PWM
1～65535ms
channel;
Read the ADC value of the device, where 0 channel can read the
device power voltage value, and the ADC can detect 3.7V voltage
Read 0～3700mv
when the voltage is up to 3.7V;
E180-ZG120B User Manual
16