Siemens SINAMICS GL150 Operating Instructions & Installation Instructions page 115

After performing repairs, refasten all cable ducts whose cover faces downward with a cable tie.
The cable ties must be located at the same positions as in the delivered state. You will find more
information in "Fastening the cable ducts with cable ties (Page 86)".
NOTICE
Damage caused by an incomplete repair
In the case of damage, several components can have a fault condition. Consequential
damage can occur if the device is recommissioned but the repair work carried out was not
complete.
● Check whether secondary faults have occurred on components which have failed.
Measures in the event of an error
It is not possible to fully test repairs that are carried out on site. Return the defective module
back to the manufacturing plant for repair. The relevant address is available from your Siemens
contact person.
Always enclose the following information:
● Type and serial number
● Time and date of the failure
● Description of the fault profile
● Operating point, currents and voltages
● Log file with fault messages
● Copy of the CompactFlash card
● If possible, hard copies from the plotter or screenshots
● Mounting location
Danger when components are incorrectly replaced
Incorrectly replacing components can result in death, serious injury, or material damage.
● Only replace components that are described in the following sections. All other
SINAMICS GL150 6SL38502UM114PA0Z
Operating Instructions Rev.201910281441 EXAMPLE
Replace the components involved.
Specify what happened when the component failed.
Specify the equipment identifier. You can find the item code on the component and close to
the slot.
WARNING
components may only be replaced by Siemens service personnel. In this case, contact the
Service Center.
Maintenance
9.7 Repairs
115