Block Out Configuration - Yealink SIP-T2 Administrator's Manual

Permitted
String within 16 characters
Values
Default Blank
Web UI Settings > Dial Plan > Area Code > Code
Parameter dialplan.area_code.min_len
It configures the minimum length of the entered number.
Description
Note: It works only if "dialplan.digitmap.enable" and "account.X.dialplan.digitmap.enable" are set to 0
(Disabled).
Permitted
Integer from 1 to 15
Values
Default 1
Web UI Settings > Dial Plan > Area Code > Min Length (1-15)
Parameter dialplan.area_code.max_len
It configures the maximum length of the entered number.
Description
Note: The value must be larger than the minimum length. It works only if "dialplan.digitmap.enable"
and "account.X.dialplan.digitmap.enable" are set to 0 (Disabled).
Permitted
Integer from 1 to 15
Values
Default 15
Web UI Settings > Dial Plan > Area Code > Max Length (1-15)
Parameter dialplan.area_code.line_id
It configures the desired line to apply the area code rule. The digit 0 stands for all lines. If it is left
blank, the area code rule will apply to all lines on the IP phone.
Description
Note: Multiple line IDs are separated by commas. It works only if "dialplan.digitmap.enable" and
"account.X.dialplan.digitmap.enable" are set to 0 (Disabled).
0 to 16 (for T57W/T54W/T48U/T48S/T48G/T46U/T46S/T46G/T29G)
0 to 12 (for T53W/T53/T43U/T42U/T42S/T42G)
0 to 6 (for T41P/T41S/T27G)
Permitted
0 to 4 (for T33P/T33G)
Values
0 to 3 (for T40P/T40G/T23P/T23G)
0 to 2 (for T31P/T31G/T31/T21(P) E2)
0, 1 (for T30P/T30/T19(P) E2/CP920)
Default Blank
Web UI Settings > Dial Plan > Area Code > Account

Block Out Configuration

The following table lists the parameters you can use to configure the block out.
Parameter dialplan.block_out.number.X
Description It configures the block out numbers.
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg
Call Features
360