Table of Contents
Advertisement
CB1200 Pellet Insert
Moisture
Always burn dry fuel. Burning fuel with high moisture
content takes heat from the fuel and tends to cool the
appliance, robbing heat from your home. Damp pellet fuel
can clog the feed system.
Size
•
Pellets are either 1/4 inch or 5/16 inch (6-8mm)
in diameter
•
Length should be no more that 1-1/2 inches (38mm)
•
Pellet lengths can vary from lot to lot from the
same manufacturer
•
Due to length variations, the flame height (feed rate)
may need adjusting occasionally.
Performance
•
Higher ash content requires the ash drawer to be
emptied more frequently
•
Hardwoods require more air to burn properly
•
Premium wood pellets produce the highest heat output.
•
Burning pellets longer than 1-1/2 inches (38mm)
can cause an inconsistent fuel feed rate and/or
missed ignitions.
Changing to Different Fuel Type
•
Empty the hopper of the previous fuel
•
Thoroughly vacuum hopper before filling with the
new fuel
The burn rate, BTU content and heat output will all vary
depending on the fuel selected.
CAUTION
Tested and approved for wood pellets and shelled corn.
Burning of any other type of fuel voids your warranty.
Storage
•
Wood pellets should be left in their original sealed bag
until using to prevent moisture absorption.
•
Do not store any pellet fuel within the clearance
requirements or in an area that would hinder routine
cleaning and maintenance.
E. Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have been
met. Pay particular attention to the fire protection,
venting and thermostat installation instructions.
2. Double check that the ash drawer and firebox
are empty!
3. Check the position of the thermocouple, located
above the fire pot, and make sure that it protrudes
approximately 3/4 inch (19mm) into the fire pot.
4. Close the front door.
CAUTION
Tip of thermocouple must be in contact with the inside
end of the thermocouple cover.
Missed ignitions can occur.
10
F. Filling the Hopper
Open the hopper lid by lifting the handle. Fill the hopper
with fuel. Close the hopper lid. The unit will not feed with
the hopper lid open and the fire will go out.
NOTE: UNIT CAN USE 1:1 PELLET/CORN MIXTURE.
We recommend the use of a 1:1 pellet/corn
mixture. The only change in operation is that the
feed rate may require a slight adjustment.
G. General Operating Information
1. Thermostat Calls For Heat
The appliance is like most modern furnaces; when
the thermostat calls for heat, your appliance will
automatically light and deliver heat. When the room
is up to temperature and the thermostat is satisfied,
the red call light will shut off and the appliance will
shut down (Figure 10.1).
2. Heat Output Controls
This appliance is equipped with a heat output control
switch that has three settings or burn rates; low,
medium and high. The appliance will turn on and off as
the thermostat demands. When the thermostat calls for
heat, the appliance will always start up on High. After
burning approximately 4 minutes, the appliance will
then burn at the rate at which it was originally set. If
the appliance is set at one of the lower settings, it will
run quieter but takes longer to heat up an area than
if it were set at a higher burn rate. Regardless of the
burn rate, when the area is warm enough to satisfy the
thermostat, the appliance will shut off.
Figure 10.1
7027-805C
Control Box
Heat Output Switch
Reset Button
Red Call Light
Fuse
June 4, 2019
Blue
Blinking
Light
Red / Green
Light
Advertisement
Table of Contents
