Table of Contents
Advertisement
CB1200 Pellet Insert
C. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact
your dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
E. Mobile Home Approved
•
This appliance is approved for mobile home
installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
•
The structural integrity of the mobile home floor, ceiling,
and walls must be maintained.
•
The appliance must be properly grounded to the frame
of the mobile home and use only Listed pellet vent
Class "L" or "PL" connector pipe.
•
Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
F. Non-Combustible Materials
Material which will not ignite and burn, composed of any
combination of the following:
-
Steel
-
Plaster
-
Brick
-
Iron
-
Concrete
-
Tile
-
Glass
-
Slate
Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace of 750°C.
G. Combustible Materials
Material made of/or surfaced with any of the
following materials:
-
Wood
-
Compressed Paper
-
Plant Fibers
-
Plastic
-
Plywood/OSB
-
Sheet Rock (drywall)
Any material that can ignite and burn: flame proofed or not,
plastered or non-plastered.
H. Sleeping Room
When installed in a sleeping room it is recommended
that 3ft of vertical be installed prior to horizontally exiting
the room and a smoke/CO alarm be installed in the
bedroom.  The size of the room must be at least
50ft³ per 1,000 Btu/hr stove input, if the stove exceeds the
room size, out air must be installed.
4
I. California - Prop65
This product and the fuels used to operate this product (wood), and
the products of combustion of such fuels, can expose you to
chemicals including carbon black, which is known to the State of
California to cause cancer, and carbon monoxide, which is known to
the State of California to cause birth defects or other reproductive
harm. For more information go to: WWW.P65Warnings.ca.gov
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth &
Home Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling
all components.
•
Operating appliance without legs attached (if
supplied with appliance).
•
Do NOT Over fire - If appliance or chimney connector
glows, you are over firing.
Any such action that may cause a fire hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer
of this appliance, reserves the right to alter
its products, their specifications and/or price
without notice.
7027-804G
WARNING
WARNING
05/21
Advertisement
Table of Contents
