Toro Spray Master Operator's Manual page 43

Cleaning the External Components
1. Using a hose to wash off the outside of the
sprayer tank with clean water.
Note:
Do not use a power washer to clean
the machine. The high-pressure water
may force residual corrosive materials into
spreader-spreader components.
2. Remove and clean the sprayer nozzles; refer to
Cleaning the Sprayer Nozzles (page
Note:
Replace damaged or worn nozzles.
3. Allow the spreader-sprayer to completely dry
before the next use.
Cleaning the Strainer
Service Interval: After each use
Important:
If you used wettable-powder
chemicals, clean the strainer after each time that
you rinse the sprayer tank.
1. Rotate the left tank and right tank return and
suction valves to the closed position
Figure 50
1. Left tank return valve
(open position)
2. Left tank suction valve
(open position)
2. Align a drain pan under the strainer
Figure 51
44).
(Figure 50).
g311408
3. Right tank suction valve
(open position)
4. Right tank return valve
(open position)
(Figure 51).
g311412
3. Rotate the strainer bowl counterclockwise and
remove the bowl and screen from the body of
the strainer (Figure
Note:
Remove the strainer bowl by hand.
Note:
Replace the gasket or screen or both if
these parts are worn or damaged.
1. Strainer bowl
2. Gasket
4. Allow any residual chemical solution to drain
from the strainer body.
Note:
Dispose of the waste solution according
to local codes and the chemical manufacturer's
instructions.
5. Use a soft-bristle brush and clean water to clean
the screen and bowl.
6. Install the screen into the strainer body
52).
7. Install the gasket and strainer bowl onto the
strainer body, and hand tighten the bowl
52).
43
52).
Figure 52
3. Screen
4. Strainer body
g311410
(Figure
(Figure