Toro Spray Master Operator's Manual page 25

apply the granular materials to the work site, and
finish by cleaning the spreader.
Important:
When you use your spreader,
thoroughly clean it at the end of the day.
Adjusting the Impeller-Speed
Control
Figure 18
1. Knob (impeller-speed control)
Use the impeller-speed control
hydraulic motor that drives the impeller, adjust the
impeller-motor speed and adjust the broadcast pattern
width, and shut off the impeller motor.
•
Rotate the impeller control knob counterclockwise
to run the impeller motor, increase motor speed
and increase the broadcast pattern.
•
Rotate the impeller control knob clockwise to
decrease motor speed and decrease the broadcast
pattern, or shut off the impeller motor.
g311592
(Figure 18) to start the
Hopper Controls
1. Unlock
2. Lock
3. Hopper-door control
Adjusting the Hopper-Door Control
Important:
Close and lock the hopper-door
control when you are not spreading.
Use the hopper-door control to open and close
granular-substance flow from the hopper.
1. Rotate the handle of the hopper-door control
counterclockwise to unlock the control
19).
2. Open or close the hopper door as follows:
•
Pull the handle to allow granular product to
flow from the hopper to the impeller.
•
Push the handle to shut off the flow of
granular product.
3. Rotate the handle of the hopper-door control
clockwise to lock the control
Adjusting the Deflector Control
Use the deflector control to adjust the broadcast of
granular product from left side of the impeller. The
deflector control is pulled during normal spreader
operation.
1. Rotate the handle of the deflector control
counterclockwise to unlock the control
19).
2. Adjust the broadcast deflector as follows:
25
Figure 19
4. Deflector control
5. Diffuser control
(Figure
(Figure 19).
(Figure
g312313