Toro Spray Master Operator's Manual page 29

Filling the Spreader Hopper
Maximum hopper weight capacity: 54 kg (120 lb)
1. Drive the machine to the work site.
2. Move the machine to a level surface, move
motion-control lever to the N
shut off the engine, wait for all moving parts to
stop, remove key, and engage parking brake.
3. Ensure that the hopper-door control is in the fully
forward (closed) position; refer to
Hopper-Door Control (page
4. Use the Spreading Charts (page 30)
determine the setting for the drop-rate cam
(Figure 23).
Note:
If the setting is not listed for the type of
material that you are using, set the cam to the
setting with a lower value then adjust as needed.
Figure 23
1. Cover
2. Hopper
5. Remove the cover from the hopper, add the
material that you are spreading, and install the
cover onto the hopper
Note:
Do not overload the hopper; the
maximum weight capacity of the hopper is 54
kg (120 lb).
Note:
You may place extra bags of granular
material in the cargo boxes behind the spray
tanks.
position,
EUTRAL
Adjusting the
25).
to
g312531
3. Drop-rate cam
(Figure 23).
29