Cleaning And Lubricating The Spreader - Toro Spray Master Operator's Manual

Cleaning and Lubricating
the Spreader
Cleaning the Spreader
Service Interval: After each use
Important:
Do not use brackish or reclaimed
water to clean the machine.
1. Drive the machine to a designated cleaning area
with a level surface.
2. Move the motion-control levers to the N
position, shut off the engine, wait for all moving
parts to stop, remove key, and engage parking
brake.
3. If installed, remove the cover, and empty the
hopper.
4. Open the hopper gate to the maximum open
position:
A. Pull rate gate linkage outward
B. Rotate the drop rate cam until the slot aligns
with the linkage
C. Push in the linkage
Figure 47
1. Slot–maximum position
5. Rotate the 2 hopper screens and remove them
from the hopper pan
EUTRAL
(Figure 47).
(Figure 47).
(Figure 47).
2. Linkage
(Figure 48).
1. Hopper pan
6. Remove any pellet or granular material at the
bottom of the hopper.
7. Using a hose to spray the inside and outside of
the entire spreader with clean water.
Note:
Do not use a power washer to clean
the machine. The high-pressure water
can force residual-corrosive materials into
sprayer-spreader components.
8. Install the hopper screens.
9. Allow the hopper to drained, pull the linkage,
and adjust the drop-rate cam to position 9.
g027033
41
Figure 48
2. Screen
g312831