Toro Spray Master Operator's Manual page 44

Cleaning the Sprayer Nozzles
Service Interval: After each use
1. Rotate the nozzle cap 90° counterclockwise and
remove the cap from the nozzle body
53).
Figure 53
1. Nozzle body
2. Strainer
2. Remove the sprayer tip and strainer from the
nozzle body (Figure
Note:
Replace any worn or damaged nozzle
parts.
3. Use a soft-bristle brush and clean water to clean
the nozzle tip and strainer.
4. Assemble the strainer into the nozzle body
(Figure 53).
5. Assemble the sprayer tip into the nozzle cap
(Figure 53).
6. Install the tip and cap onto the nozzle body
(Figure 53).
Note:
Use the slot to rotate the atomizer
54) of the sprayer tip forward (in-line with the
flow-regulator case of the nozzle body).
(Figure
3. Sprayer tip
4. Nozzle cap
53).
(Figure
g311414
1. Flow-regulator case
2. Atomizer slot
(aligned—correct)
7. Rotate the nozzle cap 90° clockwise
8. Repeat steps
nozzles.
44
Figure 54
3. Atomizer slot (incorrect)
1 through 7 for the other spray
g311417
(Figure 53).