Toro Spray Master Operator's Manual page 32

•
If the material is broadcast too heavy at the
left side of the machine, push the diffuser
control down slightly; refer to 3 of
•
If the material is broadcast too heavy at the
right side of the machine, pull the diffuser
control up slightly; refer to 4 of
3. Lock the spreader-pattern control by turning the
handle clockwise 90°; refer to 5 of
Using the Deflector Gate
Use the deflector control to temporarily stop or deflect
granular material away from sidewalks, parking lots,
patios, or anywhere the granular chemicals are not
desired.
Note:
The deflector gate changes the discharged of
materials from the left side of the spreader only.
Figure 26
1. Fence
2. Flowers
•
Pull the deflector-control handle to broadcast
granular product from the left side of the impeller.
Figure 25.
Figure 25.
Figure 25.
g312556
3. Deflector gate lowered
1. Deflector-control handle
2. Pull (broadcast at the left
and right sides)
•
Push the handle to temporarily block granular
product from broadcasting at the left side of the
impeller.
Spreading Granular Material
1. Start the engine, and adjust the throttle midway
between the S
2. Rotate the knob of the impeller-speed control to
run the impeller motor
1. Impeller-speed control
2. Deflector control
3. Move the throttle to the F
the machine forward.
4. Open the hopper-door control to begin spreading
the granular material
32
Figure 27
3. Push (block left side
product broadcast)
and the F positions.
LOW AST
(Figure 28).
Figure 28
3. Diffuser control
4. Hopper-door control
position, and drive
AST
(Figure 29).
g312555
g311623